Denon AVR-2113CI Owner's Manual page 126

Language
Set the language for display on the menu screen.
English / Français / Español
"Language" can also be set by the following procedure. However, the menu screen is not displayed.
Following the display content to make the setting.
ZONE2 SOURCE
1. Press and hold the main unit's
"V.Format : <NTSC>" appears on the display.
DIMMER
2. Press the main unit's and set "Lang. : <ENGLISH>".
TUNER PRESET CH +, –
3. Use the main unit's
STATUS
4. Press the main unit's to complete the setting.
ZONE2 Setup
Set the audio to play back with ZONE2.
• "ZONE2 Setup" is displayed when "ZONE2" is selected with "Assign Mode" (vpage 115).
Setting items
Lch Level –12dB – +12dB (0dB)
Adjust the left channel
output level.
Rch Level –12dB – +12dB (0dB)
Adjust the right channel
output level.
Off : Do not set a maximum volume.
Volume Limit
Make a setting for 60 (–20dB) / 70 (–10dB) / 80 (0dB)
maximum volume.
This is displayed from –79 dB to 18 dB when "Scale" (vpage 103)
is set to "–79.5dB – 18.0dB".
Power On Volume Last : Use the memorized setting from the last session.
Define the volume setting Mute : Always mute when power is turned on.
that is active when the 1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
power is turned on.
This is displayed from –79 dB to 18 dB when "Scale" (vpage 103)
is set to "–79.5dB – 18.0dB".
Mute Level Full : The sound is muted entirely.
Set the amount of –40dB : The sound is attenuated by 40 dB down.
attenuation when muting –20dB : The sound is attenuated by 20 dB down.
is on.
DVD
Default settings are underlined.
Setting details
STATUS
and for at least 3 seconds.
and set the language.
Default settings are underlined.
Setting details
Zone Rename
Change the display title of each zone to one you prefer.
MAIN ZONE / ZONE2
• Up to 10 characters can be input.
• For character input, see page 98.
Quick Select Names
Change the "Quick Select" display title to one you prefer.
Quick Select 1 / Quick Select 2 / Quick Select 3 / Quick Select 4
• Up to 16 characters can be input.
• For character input, see page 98.
Auto Standby
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, "Auto Standby" is
displayed on the display of this unit and the menu screen.
30min : The unit goes into standby after 30 minutes.
60min : The unit goes into standby after 60 minutes.
Off : The unit does not go into standby automatically.
123
Setting details
Setting details
Default settings are underlined.
Setting details
General