Dexter Laundry T750 EXPRESS Installation & Operation Instructions page 12

COIN WASHER CYCLE PARAMETER RANGES
The range of each cycle parameter is shown below:
Cycle Time "ct"
Water Temperature "t"
Water Level "L"
Delay Fill "dF"
Spin Time "S"
"IS"
COIN WASHER DEFAULT CYCLE
The following table shows the complete details for the coin washer default cycle.
Bath Bath Cycle
Time
(min.)
Prewash 0
Wash 9
Rinse 1 4
Rinse 2 0
Final 5
Rinse
Note *
0 to 15 minutes for Prewash, Rinse1 and Rinse2
3 to 15 minutes for Wash and Final Rinse
For the bathes that can, if the time is set to zero, then the
bath will be eliminated from the cycle.
HH – hot, CH – warm, CC – cold
The owner can set the bath default. For the wash bath, the
customer overrides the default for that cycle when the
temperature is selected.
LO – low
The owner can change the displayed value, but for a coin
washer only LO will be put into the cycle.
The selections are "d" for delay the bath time until water
level is reached or "t" to countdown bath time during the
fill.
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2
1 to 10 minutes for Final Spin.
The owner can change the displayed value, but for a coin
washer only 0 will be put into the cycle.
Water
Temp.
CC
CH
CC
CC
CC
These default values are preset and cannot be changed.
Water Delay Fill
Level *
LO t
LO t
LO t
LO t
LO t
Spin Time IS *
(min.)
0 0
0 0
1 0
0 0
4 0