Table of Contents
Advertisement
Installation
Before operating your new appliance please read
GB
this instruction booklet carefully. It contains
important information concerning the safe installation
and operation of the appliance.
Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
The appliance must be installed by a qualified
professional according to the instructions provided.
Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.
Positioning and levelling
It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
! This cooker should be installed directly on
the floor. Do not install this cooker on an
artificial base of any kind.
Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).
! Important: Do not install this appliance
adjacent to the door or other means of
access to minimise the likelihood of persons
using the door making contact with pans on
the hob surface.
To install the appliance correctly:
• Place it in the kitchen, dining room or the bed-sit
(not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 200 mm
away from them.
HOOD
600
Min.
mm.
• Do not position blinds behind the cooker or less
than 200 mm away from its sides.
• Any hoods must be installed according to the
instructions listed in the relevant operating manual.
2
•
If the cooker is
installed underneath a wall
cabinet, there must be a
minimum distance of
420 mm between this
cabinet and the top of
the hob.
This distance should be
increased to 700 mm if
the wall cabinets are
flammable (IAA BECKHA).
example by a child climbing onto the top oven door,
the supplied safety chain must be installed. Ensure
the chain is secured to the rear wall of the oven as
shown, and attach the chain to a screw secured to
the wall behind the appliance.
Levelling
If it is necessary to level the
appliance, screw the
adjustable feet* into the places
provided on each corner of the
base of the cooker (IAABECKHA).
The legs* provided with the
appliance fit into the slots on
the underside of the base of
the cooker.
Electrical connection
Ovens with a three-pole power supply cable are
designed to operate with alternated current at the
supply frequency and voltage indicated on the data
plate (at the bottom of the oven dashboard). The
earthing conductor of the cable is the yellow-green
conductor.
*
Only available in certain models.
• The cooker is fitted
with a safety chain that
must be attached to a
screw, secured to the
wall behind the
appliance.
! In order to prevent
accidental tipping of
the appliance, for
Advertisement
Table of Contents
