Setting Initial Copy Modes - Kyocera Copystar CS-2035 Service Manual

2HA/2HB
Connect the power cord.
1. Connect the power cord to the connector on the copier.
2. Insert the power plug into the wall outlet and turn the power switch on.
Installing the toner (maintenance item U130).
1. Enter the maintenance mode by entering "10871087" using the numeric keys.
2. Enter "130" using the numeric keys and press the start key.
3. Press the start key to execute the maintenance item.
Installation of toner starts and "10" is indicated in the copy quantity display. Each time one minute elapses, the
indicated value decrements. When the installation is complete, "Gd" will be displayed if the installation is suc-
cessful or "nG" will be displayed if it has failed.
4. Press the stop/clear key.
Load paper.
1. Load paper in the drawer.
Output an own-status report (maintenance item U000).
1. Enter "000" using the numeric keys and press the start key.
2. Select "d-L" and press the start key to output a list of the current settings of the maintenance items.
3. Press the stop/clear key.
Exit maintenance mode.
1. Enter "001" using the numeric keys and press the start key.
The machine exits the maintenance mode.
Make test copies.
1. Place an original and make test copies.
Completion of the machine installation.
1-2-3

Setting initial copy modes

Factory settings are as follows:
Maintenance
item No.
U253 Switching between double and single counts
U254 Turning auto start function on/off
U258 Switching copy operation at toner empty detection
U260 Changing the copy count timing
U277 Setting auto application change time
U342 Setting the ejection restriction
U343 Switching between duplex/simplex copy mode
U344 Setting preheat/energy saver mode
1-2-6
Contents Factory setting
Double count
ON
SINGLE MODE
After ejection
30
ON
Simplex copy
ENERGY STAR