THOMSON TG782 Setup And User Manual page 41

Enter your VoIP account settings
Proceed as follows:
1 In the Navigation bar, click Configure.
2 Under Service Configuration, select Enable Telephony.
3 Under Telephone Numbers, complete the following fields:
SIP URI:
The Uniform Resource Identifier (URI) of your SIP account (for example: 050579, john.doe,...). This is
the telephone number that people have to dial to call you.
Username:
The user name of your VoIP account (for example: 050579, john.doe,...).
Password:
The password of your VoIP account.
Displayname:
The name that you want people to see on the phone's screen when you are calling. Your VoIP
provider may not support this feature.
Abbreviated number:
An internal number to call the phones associated with this VoIP account.
Port:
The phone port that you want to associate with this VoIP account. If you want to use the same VoIP
account for all ports, select Port 'All'.
4 Click Apply.
Verifying Telephone Connectivity
Proceed as follows to verify the voice connection:
1 Make sure the Thomson Gateway is turned on.
2 Check whether your phone is properly attached to the Thomson Gateway.
3 Make sure the Internet telephony service is enabled and configured.
4 The Phone LED must be solid green.
5 Pick up your phone, wait for the dialling tone, and dial the number. If you dial a '#' after the phone
number, the phone number will be called over the traditional telephone network.
The phone(s) attached to the Thomson Gateway can only receive incoming VoIP calls, as long as
your Thomson Gateway is turned on and the Phone LED is lit.
For calls over the traditional telephone, your phones are line-powered by the telephone company
and can therefore always be reached, even if the Thomson Gateway is turned off.
Multiple Identities
You can assign up to three Internet telephone numbers or URIs to one or both phone ports, or you can assign
a common number to both phone ports.
Using Multiple Identities
Proceed as follows:
1 Browse to the Thomson Gateway
2 On the Toolbox menu, click Telephony.
3 In the Navigation bar, click Configure.
4 In the Pick a task list, click Use multiple identities.
E-DOC-CTC-20090619-0001 v1.0
GUI.
4 Telephony
35