Table of Contents
Advertisement
12 Inch Tilt/Lectern Touchpanels
Physical Views of the TPS-4500L Touchpanel (Front & Side)
4 • 12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L
5
When loading VT Pro-e files or firmware through the RS-232 port of the control system, be sure that
the baud rate is at 38400 (Cresnet speed) or lower. Otherwise, the Viewport may post the "Transfer
Failed" message.
6
These control systems do not support loading of firmware or VT Pro-e files to the TPS-series panels
through the RS-232 port of the control system. In order to load these files to the TPS-4500/L when
using these control systems, use the RS-232 port on the TPS-4500/L.
7
Additional Flash memory can be purchased, refer to "Memory" on page 7. The complexity of the
control screens and the sampling of the WAV files influence memory usage.
NOTE: Crestron software and any files on the website are for Authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).
Physical Description
The TPS-4500L's 12-inch (30.5-cm) touch sensitive viewing screen is located on the
front of the TPS-4500L touchpanel, shown below and on the next page. The
electronic hardware is housed in a black metal enclosure. All video, RS-232, and
network connections are made at the rear of the unit. Two color bezels are available:
black (TPS-4500LB) and white (TPS-4500LW).
NOTE: Video connections are available after installing the TPS-VIDL-1 or
TPS-VIDL-2 into the TPS-4500L touchpanel.
13.43 in
(34.11 cm)
9.68 in
(24.59 cm)
NOTE: For cutout dimensions, refer to "Appendix B: Cutout Detail of Supplied
Template" on page 43.
Crestron TPS-4500 & TPS-4500L
7.26 in
11.04 in
(18.44 cm)
(28.05 cm)
Operations Guide - DOC. 5891A
2.70 in
(6.85 cm)
Advertisement
Table of Contents
