Eiki LC-XB100A Owner's Manual page 55

Pointer
You can emphasize a part of the projected image with this
function. Use the Point
ed
(Large, Middle or Small) , Arrow, Finger or Dot and press
the SELECT button. See "Pointer Function" on page 13.
Remote control
The eight different remote control codes (Code 1–Code 8)
are assigned to the projector; the factory-set, initial code
(Code 1) and the other seven codes (Code 2 to Code 8).
The same code should set on both the projector and the
remote control. For example, operating the projector in
Code 7, the remote control code also must be switched to
Code 7.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control:
While holding down the MENU button, press the IMAGE
button the number of times corresponding to the remote
control code for the projector. See "Remote Control Code"
on page 13.
Note:
✔
• When different codes are set on the projector and on the remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the code on the projector.
• If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
buttons to choose Spotlight
Pointer
Arrow
Remote control
Setting
55