Table of Contents
Advertisement
Setting
Standby mode
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered off.
Eco . ........... Select Eco when you do not use the projector
via network. The projector's network function
will stop when turning off the projector.
Refer to the owner's manual "Network Set-up and Operation".
✔ Note:
• Factory default is Network.
• When selecting Network, the cooling fans may be running
depending on the temperature inside the projector even if
the projector is turned off.
• When Eco mode is selected and the projector is in Stand-by,
the communication of RS-232C serial port is not available.
Lamp control
Lamp control
This function allows you to change brightness of the
screen.
Normal ...... Normal brightness
Eco . ........... Lower brightness reduces the lamp power
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 .............. The lamp can be turned on even after
Mode 2 .............. The lamp can be turned on even after
✔ Note:
• Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
• If Mode 2 has been selected and the projection lamp
exceedes the recommended total hours of use, the
replacement icon will be displayed at the time of power-
on. Then the projector will turn off after 3 minutes.
Lamp replacement icon
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.48), during Freeze
(p.27), or No show (p.28).
54
consumption and extends the lamp life.
exceeding the recommended total
hours of use.
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Lamp life control
Advertisement
Table of Contents
