Adjusting The Feet; Electrical Connection; This Appliance Must Be Earthed; Fitting A Different Plug - Grundig GSF 41820 W User Instructions

Installation

Adjusting the feet

If the door of the product cannot be closed
properly or if the product wobbles when
you push it slightly, then you need to adjust
the feet of the product. Adjust the feet of the
product as illustrated in the relevant section.

Electrical connection

Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
If the supply cord or the mains lead is
damaged please do not replace it yourself.
The supply cord or the mains lead must be
replaced by a Authorised Service Agent or a
similarly qualified person.
DISHWASHER / USER INSTRUCTIONS
A
This appliance must be
earthed
If the fitted moulded plug is not
suitable for your socket, then the
plug should be cut off and an
appropriate plug fitted.
Destroy the old plug, which is cut
off as a plug with a bared cord
could cause a shock hazard if
inserted into a socket elsewhere
in the house.
The moulded plug on this
appliance incorporates a 13A
fuse. Should the fuse need to
be replaced an ASTA approved
BS1362 fuse of the same rating
must be used. Do not forget to
refit the fuse cover. In the event
of losing the fuse cover, the
plug must not be used until a
replacement fuse cover has been
fitted. Colour of the replacement
fuse cover must be the same
colour as that visible on the pin
face of the plug. Fuse covers
are available from any good
electrical store.

Fitting a different plug

As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked 'E' or with the symbol
coloured green and yellow or green.
2. Connect the blue (neutral) wire to the
terminal in the plug marked 'N' or
coloured black.
or
11 / 41 EN