Information; Remote Code; Lamp Reset - JVC DLA-X970R Instructions Manual

Remote Code

For changing the remote control code.
Setting
A
B
You need to configure the remote control according to the settings of this unit.
0
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to "A"
0
The backlight of the remote control blinks 2 times: change the remote control code to "B"
0

Lamp Reset

For resetting the lamp time to "0".
Æ "Resetting the Lamp Time" (P. 60)

Information

Setting
Input
Source
(Displayed only during video signal input)
Resolution
(Displayed only during PC signal input)
H Frequency
(Displayed only during PC signal input)
V Frequency
(Displayed only during PC signal input)
Color Depth
Color Space
Lamp Time
Soft Ver.
PS Ver.
Change the remote control code from "B" to "A".
Change the remote control code from "A" to "B".
Displays video input terminal.
Displays the input source.
Displays the image resolution.
Displays the horizontal frequency.
Displays the vertical frequency.
Displays the color bit depth of the input video signal.
Not displayed when YCbCr (4:2:2) is input.
0
Displayed when Deep Color information is received from the source device.
0
Displays the color space of the input signal.
Displays the lamp time.
Displays the firmware version.
Displays the version of image quality data.
Description
Description
57