Table of Contents
Advertisement
SYSTEM SETUP: Advanced menu
Submenu
HDMI Range
Password
Panel Key Lock
Reset All
Settings
INFORMATION menu
Submenu
Input
Picture Mode
28
Menu Functions
•
Auto: Sets the projector to detect the HDMI range of the input signal
automatically.
•
Enhance: Sets the HDMI color range as 0 - 255.
•
Standard: Sets the HDMI color range as 16 - 235.
For security purposes and to prevent unauthorized use, you may set up
password security for the projector. This limits use of the projector to only those
who know the correct password. If you enter an incorrect password 5 times in
succession, the projector will automatically shut down in a short time.
You will be inconvenienced if you enable this function yet forget the password
somehow. Do make a note of your password, and keep the note in a safe
place for later recall.
You will be asked to set a new password if no password has been set before.
As the on-screen display indicates, the 4 arrow keys ( / / / ) respectively
represent 4 digits (1, 2, 3, 4). Use the arrow keys to set a 6-digit password. The
digits display as ****** when you enter them.
•
Change Password
You will be asked to enter the current password before changing to a new one.
•
Power On Lock
You will be asked to enter the current password before changing the setting.
Once a password has been set and the power on lock is enabled, the
projector cannot be used unless the correct password is entered every time
the projector is started.
If you forget the password, seek help from the local JVC service center. You
may be required to provide proof of purchase documentation to verify that
you are an authorized user of the projector.
With the control keys on the projector locked, you can prevent your projector
settings from being changed accidentally (by children, for example).
When you select On to enable this function, no control keys on the projector
will function, except
To unlock the keys, press and hold
Off here using the remote control.
The function is accessible through the remote control or keypad.
Returns all settings to the factory preset values.
The following settings will still remain: Picture Mode, Brightness, Contrast,
Color, Tint, Sharpness, Aspect Ratio, e-shift, Projector Mode, Password,
Select Gamma, Color Temperature, 3D Color Management, MoviePro.
Displays the current signal source.
Displays the current picture mode under the PICTURE menu.
Functions and Descriptions
POWER.
on the projector for 3 seconds or select
Functions and Descriptions
Hide quick links:
Advertisement
Table of Contents
