Table of Contents
Advertisement
Chapter 2: WEB Configuration
Note: After you Enabled the WPS you will get the options as show in Fig.35. And the WPS Config State box
will show its configuration status.
Device Name: By using this you can change the factory default to a name of your choice which is up to 32
characters long as like SSID.
WPS Setup AP: Here you do not need to change anything so, just skip this step.
WPS Add Client: T
But, the default selection will be "PIN".
If you select "Push-Button", then the WPS Add Client option will appear as shown below.
And then if you click "Add" button then WPS Setup AP page will appear as shown in Fig.36
And WPS Configure Status will be "In progress", after establishing the connection the WPS Configure
Status will be "Success!" as shown below. After successful connection the client will get IP address from AP
and then internet will be accessible.
Illustrations contained in this document are for representation only.
here are two methods "Push-Button" and "PIN". Select the method you want.
Fig. 37
Fig. 36
Fig. 38
47
Hide quick links:
Advertisement
Table of Contents
