Service And Customer Care; Troubleshooting Guide - Kenwood BLEND-X FRESH BLP40 Instructions Manual

service and customer
care
If you experience any
l
problems with the operation
of your appliance, before
requesting assistance refer to
the "troubleshooting guide"
section in the manual or visit
www.kenwoodworld.com.
Please note that your product
l
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the
country where the product was
purchased.

troubleshooting guide

Problem
The Blender will not
operate.
Blender or mill leaking
from blade assembly.
Sealing ring missing from
blade unit when removed
from packaging.
If none of the above solve the problem see "Service & Customer Care".
If your Kenwood product
l
malfunctions or you find any
defects, please send it or bring
it to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
l
Kenwood in the UK.
Made in China.
l
Cause
No Power
Blender not assembled
correctly.
Seal missing.
Seal incorrectly fitted.
Seal damaged.
The seal is packed
pre-fitted to the blade
unit.
7
Solution
Check blender
plugged in.
Check blade unit is
fully tightened to
the goblet.
Check seal is fitted
correctly and not
damaged. To obtain
a replacement seal
see "service &
customer care".
Unscrew goblet and
check that seal is
fitted to blade unit.
To obtain a
replacement seal
see "service &
customer care".
Note: spare seal is
supplied in pack.