Rs-232 Cable; Industry Compliance; Setup; Installing The Battery Pack - Crestron MT-500C Operation Manual

Crestron MT-500C

Setup

Operations Guide – DOC. 6101
MiniTouch Color RF Wireless Handheld

RS-232 Cable

RS-232 Cable Pinouts
Sleeve
Tip
Ring

Industry Compliance

This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This section contains hardware installation and setup instructions.

Installing the Battery Pack

1. On back of MT-500C, press the latch on the battery cover and remove it
(refer to illustrations below).
Battery Cover Removal
2. Place the battery pack in the battery compartment (refer to illustration on
the next page).
3. Connect the battery pack cable to the battery connector.
Pin 2 (Tip)
Pin 2 - Transmit
Pin 5 (Sleeve)
Pin 3 - Receive
Sleeve - Ground
MiniTouch Color RF Wireless Handheld • 5
Female DB9
Pin 1
Pin 3 (Ring)