Industry Compliance - Crestron IM-TCC Operations & Installation Manual

iMedia Table Mount Computer Center
IM
1
6 • iMedia Table Mount Computer Center: IM-TCC
AUDIO
The 3.5 mm computer audio connector provides an unbalanced stereo line-level
audio input.
Maximum input level 2 V
●
Input impedance 10k Ohms
●
COMPUTER
This female DB15HD connector is used for connecting a computer's RGB
video output to the display device. A corresponding 3.5mm mini-jack is
provided for the computer sound card output.
Maximum input voltage 1.0 V
●
Input Impedance 75 Ohms (R/G/B), 1 k Ohms (H/V)
●
Refer to the following table for pin-assignments.
RGB DB15HD Pin Assignments
PIN FUNCTION
1 Red Video
2 Green Video
3 Blue Video
4 Reserved
5 Ground
6 Red Ground
7 Green Ground
8 Blue Ground
IM
This eight-pin RJ-45 transport port allows connection of the iMedia cable. It
carries audio and video signals over CresCAT-IM cable to an iMedia receiver
(IM-RX1 or IM-RX3). For more information on iMedia cable length refer to the
chart on page 3.
NOTE: Always use CresCAT-IM cable to make iMedia connections.

Industry Compliance

As of the date of manufacture, the IM-TCC has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Crestron IM-TCC
RMS
(R/G/B), 5.0 V
p-p
PIN
9
10
11
12
13
14
15
Operations & Installation Guide - DOC. 6383
(H/V)
p-p
FUNCTION
No Connect
Ground
No Connect
Monitor Sense 1
Horizontal Sync
Vertical Sync
Monitor Sense 2