Comtech EF Data CDM-600 Application Note page 5

Step Procedure
6
Connect the ground wire to the power supply by using the screw in the location near the ground spade on the power
supply. See Figure 3.
.
7
Connect the AC input and DC output connectors to the power supply.
Connectors must be correctly aligned and fully seated onto board and power supply.
CAUTION
8
Re-install the cover to the chassis and secure it using attaching screws.
9
Apply power and verify that the unit operates correctly.
If you experience a problem, or have any questions, contact Comtech EF Data Customer Support for assistance:
Copyright 2004 Comtech EFData Corp.
CDM-550/550T Modem Power Supply Replacement Procedure
Comtech EF Data Customer Support
Phone 1.480.333.4357 Email -
¤
¤
New Power
Supply
(PL/9971- 1
Rev. D)
¤
Figure 3
techsupport@comtechefdata.com
–5–
AC Input
Ground
Screw
Attaching
(5/32" max
an/PSREPLACE.DOC 8/5/04