Id Sel; Pwr; Installation/Setup; Software Installation - Crestron CNSNET Operation Manual

CRESTRON CNSNET

ID SEL

The red LED illuminates when communication between the CRESNET II system and the CNSNET is
established. Illumination indicates that the identity code of the CNSNET matches the identity code of a
network unit in the SIMPL program currently running in the CRESNET II system.

PWR

The green LED illuminates when 24 volts is supplied to the CNSNET over the network.

INSTALLATION/SETUP:

Software Installation

After creating customized control screens for a specific project with VisionPC/Create, use the "Create
Install" utility to develop VisionPC/Control disk(s). Refer to the latest revision of the VisionPC/Create
Operations Guide (Doc. 5495) for details. The VisionPC/Control disks must be installed and used in
conjunction with the CNSNET to connect to the CRESNET II control network. Virtually any electronic or
electromechanical device or subsystem can be controlled.
Before installing VisionPC/Control software, verify that Windows is open. Complete the following steps in
the order provided to ensure proper installation.
1. Insert the VisionPC/Control disk #1 into drive A: (or B:) of the PC.
2. Close all program windows except Program Manager.
3. From the Program Manager window, select File and Run to open the "Run" dialog box.
4. At the Command Line, type "A:INSTALL" (or "B:INSTALL") and select the "OK" button to run the
Crestron VisionPC/Control Installation program.
5. The installation program attempts to create the "c:\visionpc" directory to set up VisionPC/Control
software. If installation is preferred on another directory and/or drive, enter or select the path.
6. CRESTRON recommends a complete installation. Therefore, select the Full install button.
7. The program prompts the user for additional disks, as required.
8. The install program adds a set of icons to a particular Program Manager group, "VisionPC". If another
group is preferred, enter the name of the new or existing group. Select the Create button to verify the
group's identity.
The first part of VisionPC/Control software is installed. Continue with the following steps to install
files for a specific project.
R E M O T E C O N T R O L S Y S T E M S
3
PC Interface
DOC. 8085