User Selectable Dip Switch Settings For Tc8816A Data Receiver Modules Used In Tc8802 Monitor Expansion Bays - Philips Allegiant LTC 8500 Series Instructions For Use Manual

User Selectable DIP Switch
Settings for TC8816A Data Receiver
Modules used in TC8802 Monitor
Expansion Bays
NOTE: AFTER CHANGING
FOLLOWING SWITCHES, THE SYSTEM MUST BE
POWERED OFF AND ON BY THE TC8802 MAIN
POWER SWITCH.
TC8816A Data Receiver modules contain two 8
position DIP switches (S100 & S101). The functions
assigned to the upper DIP switch (S100) are
reserved and all settings should be left in the OFF
position. The options assigned to the 8 position DIP
switch S101 are as follows:
DIP Factory
Switch Default
Number Setting
1 OFF
2 OFF
3 ON
4 OFF
5 OFF
6 OFF
7 ON
8 OFF
Switch 1
This switch is reserved and should always be left off.
ANY OF THE
S101 DIP
Switch Function
Reserved
Keyboard Group
Keyboard Group
Reserved
Reserved
New Keyboard Mode
Operational Mode
Operational Mode
42
Switch 2 and Switch 3
Up to 8 system keyboards can be connected to the
rear panel of the TC8802 Monitor Expansion Bay.
DIP switches 2 and 3 determine the system keyboard
group that can be assigned to the TC8802 bay.
Follow the table below to select the desired group.
Switch 2 Switch 3
Off Off
Off On
(Default)
On Off
On On
Switch 4 and Switch 5
These switches are reserved and should always be
left off.
Switch 6
When switch 6 is ON, the TC8816A Data Receiver
module will communicate with system keyboards
using a '6 poll byte' protocol. This format is used to
provide variable speed pan/tilt control capability for
AutoDome equipped camera sites and is only
compatible with TC8550A, TC8551A, TC8553,
TC8554, and TC8555 type keyboards. The default
setting is OFF.
Switch 7
This switch determines the operational mode of the
TC8816A and must always be left on.
Switch 8
This switch determines the operational mode of the
TC8816A and must always be left off.
Keyboard Group
Reserved
Keyboards 9-16
Keyboards 17-24
Keyboards 25-32