Pre-Position Controls - Philips Allegiant LTC 8500 Series Instructions For Use Manual

Note: Auto-Pan is discontinued when the manual pan control (joystick) is used.
Auto-Iris and Auto-Focus revert to manual mode when the manual iris and focus controls are used,
respectively.
Switching to manual- ris or manual focus from auto mode reverts to the last manual setting used.
Auto-Focus/Iris is activated automatically upon pan or tilt when Auto-focus/iris Activation is on.
Manual-Iris is activated automatically upon Activating (ON) Back-Light Compensation.

Pre-Position Controls

R/D Function
Pre-position
Auto-pan left limit
Auto-pan right limit
Command lock mode activate
Command lock mode deactivate
Home Position
Move Pan position 180°
Erase record to end
Reset to factory defaults
Global Disable/Enable PP
Disable/Enable PP
NOTES
1. This setting stored with pre-position.
2. This setting stored as a default setting in non-
volatile memory (EEPROM) on R/D board and is
used to restore settings at power-up.
Default settings:
Autopan left limit = 0 degrees
Autopan right limit = 359.9 degrees
Autopan speed = 30 degrees per second
Auto-focus Activation = ON
Auto-iris Activation = ON
AutoSpeed = OFF
Spot auto-focus = OFF
Command Lock = OFF
Auto-shutter = OFF
Auto-Pivot Enabled (OFF)
Zoom Range Limit = OFF
Return Home = OFF
3. This setting stored as a default setting in non-
volatile memory in camera.
4. Pre-position #1 (if set) is automatically called-up
upon power-up just after the homing sequence.
Pre-Position # Description
1-99
101
102
103
104
110
111, 180
500 erase playback to end
899
900
901-999
5. Scan direction determined by last manual pan
6. Pre-positions can be disabled such that they do
9. This command clears all pre-positions, resets the
10. Access to certain AutoDome commands can be
11. Allegiant operators with priority level 8 are not
87
Set/Shot
set/show
set/show
set/show
set/---
set/---
recalibrate/show
---/show
set/----
set/---
disable/enable
disable/enable
direction.
not operate during an automatic call-up (tour).
They are still available for manual call-up.
EEPROMs to factory defaults, and resets the
lens and camera to defaults.
restricted when using an Allegiant switching
system. Allegiant system operators with Priority
levels 1 through 7 can activate the 'command
lock' mode by 'setting' preposition 103. Once the
lock mode is activated,
operators with priority level 8 would not be able
to change functions indicated by note 10. The
higher priority operators (1-7) can deactivate the
'command lock' mode by 'setting' preposition
104.
permitted to 'set' preposition functions.
Notes
4,11
2,11
2,11
10,11
10,11
11
10
11
9,11
10,11
6,10,11
Allegiant system