Table of Contents
Advertisement
RP57458 Dampfgarer LB6 Seite 8 Montag, 27. August 1956 9:07 21
8. Pull the water tank 11 forwards and out.
9. Fill the water tank 11 with clean
drinking water.
Note: The water level in the water tank
11 should always lie between the
"MIN" and "MAX" marks on the side.
Push the water tank 11 back into the
appliance.
10. Insert the mains plug into a suitable
mains socket, one that complies with the
technical data.
Note: When using the steaming function of
the oven, steam will constantly escape
through the steam vent 6 . Make sure that
this steam can escape freely.
5.1 Preparing the appliance
1. Insert the mains plug into a wall socket
that complies with the technical data (see
"12. Technical data" on page 25).
The display 17 shows 0:00.
8
11. Press the "FUNCTION" key 21 :
In the display 3 , the available functions
will appear.
12. Turn the control knob 5 until the 19
"SUPERSTEAM" display flashes.
13. Press the control knob 5 .
14. Wait until the 30 minutes shown on the
timer are up.
15. Unplug the mains plug and allow the
appliance to cool down.
16. Clean the appliance again. Observe
here the information in the section
entitled "9. Cleaning" on page 23.
5. Operating
2. Pull the water tank 11 forwards and out
of the appliance 7 .
3. Fill the water tank 11 with clean
drinking water.
Notes:
– The water level must be above the
"MIN" mark on the side of the tank.
– Do not overfill the water tank 11 . Do
not exceed the maximum filling level
("MAX" on side). This corresponds to
1.2 l water, which is enough for
Advertisement
Table of Contents
