Firmware Version - Netum C750 Manual

Firmware Version:
Firmware version will be displayed by scanning "$SW#VER".
Barcode P rogramming
Netum barcode scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Important Notes :
Many command barcodes only work with scanner in a particular connection
mode. Please pay attention to below symbol when you scanning the command
barcodes.
Command barcodes only apply to scanner work via Bluetooth connection.
Command bacodes only apply to scanner work via Wireless Connection.
Command bacodes only apply to scanner work via USB Wired Connection
Connection Way
Scanner can be connected to your device via bluetooth, USB receiver or USB
cable, you can choose one of the connection way to connect scanner with
your d evice.
Working Via USB C
Get Started: Connect scanner with your device via USB cable. If you use US
keyboard, it's plug and play. If you use other type of keyboard , please refer to
"keyboard language" to con
$SW#VER
able
igure the keyboard language before you use it.
(2)