Table of Contents
Advertisement
Functions of
Control Buttons and
LCD display
Control Buttons
The camera will turn itself off
if it is left idle for three
minutes.
The following section describes in detail the functions of the buttons and LCD mode
indications on your Creative CardCam Value. Refer to Figure 1-1 and Figure 1-2 for
the location of these buttons and LCDs on your camera.
The following buttons are found on your Creative CardCam Value:
Power/Mode button
To turn on your camera:
Press this button to turn on your camera. You can only turn on your camera
when it is disconnected from the computer.
To turn off your camera:
Press and hold this button for two seconds.
To change operation modes:
The same button also serves as a Mode button for changing the operation
mode of the camera. It can access seven modes:
• Single snapshot (high resolution 640 x 480 pixels, software interpolated)
• Single snapshot (low resolution 320 x 240 pixels)
• Time-delayed exposure after 10 seconds (low resolution)
• Multiple snapshots: 5 shots per second (low resolution)
• Erase Last image
• Erase All images
• Audible cue On/Off
To display the number of snapshots left:
Hold down the Power/Mode button for one second.
About your Creative CardCam Value
1-4
Advertisement
Table of Contents
