Setup; Fuse Replacement; Mounting & Rigging - Blizzard Lighting MiniSystem Manual

3. SETUP

Before replacing a fuse, disconnect the power cord.
ALWAYS replace with the same type and rating of fuse.

Fuse Replacement

1. With a flat head screwdriver, remove the fuse holder from its housing.
2. Carefully remove the damaged fuse from the holder and replace with exact
same type of fuse (2A, 250V).
Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is enough
room for ventilation. The fan or vent pathway must never be obstructed.
IMPORTANT: Regardless of the rigging option
you choose for your fixtures, always be sure to
secure your fixture with a safety cable.
Mount the fixture using a suitable "C" or "O"
type clamp. The clamps should be rated to
hold at least 10x the fixture's weight to ensure
structural stability.
Do not mount to surfaces of unknown
strength, and ensure properly rated rigging is
used when mounting fixtures overhead.
Overhead mounting requires extensive
experience, which includes calculating working
load limits, knowledge of the installation
material being used, and periodic safety
inspections.
If you lack these qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injury.
Page 7
MiniSystem™ Manual - Rev. A © 2020 Blizzard Lighting, LLC