Jayco Greyhawk Owner's Manual page 86

The controls select the energy source in this sequence:
• When 120-volt AC is available to the refrigerator:
• The light bars beside AUTO and AC show in the center display.
• After ten seconds, the light bar beside AC goes off and only the light bar beside auto
remains.
• This means that the refrigerator is operating on AC electric.
• If 120-volt AC is not available to the refrigerator:
• The light bars beside AUTO and LP GAS show in the center display.
• After ten seconds, the light bar beside LP goes off and only the light bar beside AUTO
remains.
• This means that the refrigerator is operating on propane gas.
If an energy source is available to the refrigerator, but is not operating correctly:
• A fault code appears in the center display.
• The refrigerator controls try to change to a less efficient energy source.
• If a less efficient energy source is not available:
• The refrigerator stops operation.
• Refer to the "Fault Codes" in the manufacturer's owner's manual.
MANUAL MODE OPERATION
When you select one of the manual modes of operation, the light bar beside the AUTO goes out in
the center display and only the light bar beside either AC, LP, or DC remains.
• AC means that the refrigerator is operating on AC electric.
• LP means that the refrigerator is operating on propane gas.
If the energy source is interrupted:
• The refrigerator stops operation.
• Refer to the "Fault Codes" in the manufacturer's owner's manual.
OPERATION OF PROPANE GAS IN EITHER AUTO OR MANUAL MODE
NOTE: On initial start up of the refrigerator, ignition of the propane gas may not occur
within 30 seconds.
If ignition of the propane gas does not occur within 30 seconds:
• The gas safety valve of the refrigerator closes.
• The refrigerator stops operation.
• Refer to the "Fault Codes" in the manufacturer's owner's manual.
• The fault code remains until you push the ON/OFF button two times (to stop and start the
refrigerator).
• If ignition does not occur after two or three times:
• Check the gas supply line.
• Consult your local dealer or an authorized Norcold Service Center.
• Change to manual mode and operate on AC electric.
78 Type C Owner's Manual