Jayco Greyhawk Owner's Manual page 83

ADJUSTABLE SHELVES
The shelves in the freezer and the fresh food compartment are made so you can remove them or
move them.
• To remove or move the shelf of the freezer:
• Pull the shelf forward out of the slot.
• Push it fully into the slot that you wish.
• To remove or move each shelf of the fresh compartment:
• Remove the screw from the retainer of each shelf at the rear of the refrigerator.
• Pull each shelf forward out of the slot.
• Push each shelf fully into the slot that you wish.
• Attach the retainer with the screw.
DOOR HANDLES
During travel, the door latch prevents the door from operating. When closing each door, push the
door toward the refrigerator until you hear a "click" sound.
To open each door, pull the handle away from the refrigerator.
During storage, the storage latch prevents the door from completely closing. Use it to prevent odors
when the refrigerator is stored for an extended period of time.
To operate the storage latch, open each door about 1/2" and push the storage latch into the cutout of
the strike plate. Do not use the storage latch as a travel latch because the doors will not be fully
closed.
DOOR BIN SLIDE (MODEL N982)
Each bin includes an adjustable bin slide to prevent bin contents from moving or overturning while
in transit. Push the slide against the bin contents until they are secure. To remove the door bin slid,
rotate it out of the door bin by pulling up from the bottom. To reinstall, reverse this procedure.
DOOR ALARM (MODEL N982)
If the lower door remains open and the interior light remains on for more than two minutes the light
turns off, a warning beepers sounds, a bell flashes and code A3 appears in the center display panel.
Refrigerator operation will not be interrupted; this alarm is intended to alert you to the fact that the
door is ajar. Closing the door will turn off the alarm.
INTERIOR LIGHTS
The interior light is at the top of the fresh food compartment. It comes on only when the refrigerator
is on the door is open. To replace the bulb:
1. Remove the DC power supply wires from the power board at the rear of the refrigerator.
2. Remove by pulling the cover toward the front of the refrigerator.
3. Remove the light bulb from the holder.
NOTE: Use only a GE#214-2 bulb as the replacement bulb. This bulb is available at
most retail automotive parts centers.
4. Install the replacement bulb.
5. Install the cover.
6. Connect the DC power supply wires to the power board at the rear of the refrigerator.
Appliances 75