Troubleshooting; Fault Causes And Remedies - Silvercrest SSH 600 A1 Operating Instructions Manual

Troubleshooting

This section contains important information on fault identification and
rectification.
WARNING
► Repairs to electrical appliances should only be carried out by
specialists trained by the manufacturer. Improper repairs can
cause considerable risks to users and damage to the appliance.

Fault causes and remedies

The following table will help you to identify and rectify minor
malfunctions:
Fault
The appliance
will not switch
on.
The appliance
switches itself to
standby mode.
The error code
appears on
the display 3.
NOTE
► If the above-mentioned solutions do not resolve the problem,
please contact Customer Service (see section Service).
SSH 600 A1
Possible cause
The plug is not con-
nected.
The mains socket is not
supplying any power.
The tilt cut-out has
been activated.
The set heating time
has expired.
There is a fault with the
temperature sensor.
Remedy
Insert the plug com-
pletely into the mains
power socket.
Check the house mains
fuse.
Plug the appliance up-
right into the mains sock-
et with the display 3 at
the top.
Increase the heating
time if you wish.
Contact our customer
service department.
GB │ MT │
91
■