Protective Devices; Overheating Protection; Tilt Cut-Out - Silvercrest SSH 600 A1 Operating Instructions Manual

Protective devices

Overheating protection

The appliance is fitted with a thermostatically controlled overheating
protector. If the appliance becomes too hot internally, the heating
element and fan switch off automatically. In this case, pull the ap-
pliance out of the mains socket and let it cool down for 30 minutes.
Then plug the appliance back into the mains socket and switch it on
again.
WARNING
Overheating can lead to a risk of fire!
► Check that the appliance can sufficiently dissipate the heat
generated: Is the appliance covered, are the ventilation slots
blocked or is the fan blocked?
► If possible, eliminate the problem or contact the Service Hotline
(see the section Service).

Tilt cut-out

The fan heater must always be plugged into a mains socket in an
upright position, with the display 3 at the top. The tilt cut-out switch-
es the appliance off as soon as it is tilted by a few degrees from
the upright position. As soon as the appliance is back in an upright
position, it can be switched back on again.
│ GB │ MT
■ 88
SSH 600 A1