Tilt Protection Function (Figure G); Troubleshooting; Maintenance / Cleaning; Maintenance - Silvercrest SHH 1200 C1 Operating Instructions And Safety Instructions

9.4. Tilt protection function (figure G)

The heater is equipped with a safety switch (17). This is to be found under the heater base (9). As
soon as the heater is positioned at an angle or even falls over, it is automatically switched off by the
safety switch (17).
The heater switches itself on again once it is in a safe upright position and the safety switch (17) is
pressed.
RISK OF FIRE! The safety switch (17) must not be manipulated or blocked in order to
operate the heater in a position other than upright.

10. Troubleshooting

The heater is not working

Check whether the mains plug is inserted correctly into the socket.

Check whether the mains socket provides power. If necessary, check the building fuses.
The heater does not heat

Make sure that the main switch (4) is in the 1 - ON position.

Check whether the heater is in an upright position and the safety switch (17) is pressed.

The internal overheating protection function was activated. Let the heater cool down and check
whether the ventilation slots (10) and the protection grid (5) are free.

One or more heating elements (6, 7, 8) are defective. Contact Customer Service.

11. Maintenance / cleaning

11.1. Maintenance

Servicing is necessary if the heater has been damaged or if liquids or objects have
penetrated the housing, if the heater has been exposed to rain or moisture or if it does not
work properly or has been dropped. If smoke is produced, or there are any unusual
sounds or smells, switch off the heater immediately and remove the mains plug from the
socket. In such cases, the heater should not be used until it has been inspected by
authorised service personnel. Only have qualified personnel carry out the servicing on the
device. Never open the housing of the heater.
SilverCrest SHH 1200 C1
English - 29