Removing And Replacing A Nim - Cisco ASR 1002-HX Removing And Replacing

Replacing an EPA
Step 5
Slide the EPA out of the EPA slot.
Replacing an EPA
Procedure
Step 1 Locate the guide rails that hold the EPA in place.
Step 2
Align the EPA with the guide rails and carefully slide the EPA all the way all the way into the slot until the
EPA stops.
Step 3 Use a number 2 Phillips screwdriver to fully seat the EPA by turning the captive screw clockwise.
When fully seated, the EPA should be flush with the router faceplate.
Note
Step 4
Restart the EPA using the following steps:
a) At the
b) At the
Step 5
Use the show platform command to verify whether the status of subslot 0/2 is OK.
Router# show platform
Chassis type: ASR1002-HX
Slot
--------- ------------------- --------------------- -----------------
0
0/0
0/1
0/2
.
.
.

Removing and Replacing a NIM

The OIR feature allows you to install and replace a NIM while the router is operating. You do not have to
shut down the system's power although you should not run traffic through the NIM while it is being removed.
OIR is a method that is seamless to end users on the network, and maintains all routing information and
preserves sessions.
Note As you disengage the NIM from the router, OIR shuts down all the active interfaces in the NIM.
Removing and Replacing FRUs
20
Avoid overtorquing the EPA captive screw when installing the EPA. Tighten the captive screw on
the EPA to a torque of 11 +/-1 inch-pounds.
prompt, enter hw-module subslot 0/2 start and press Enter.
router#
prompt, enter end and press Enter.
router#
Type State
ASR1002-HX ok
BUILT-IN-EPA-8x1G ok
BUILT-IN-EPA-8x10G ok
EPA-18X1GE ok
Removing and Replacing FRUs
Insert time (ago)
00:07:52
00:07:00
00:07:00
00:07:01