Cisco ASR 1002-HX Removing And Replacing page 14

Removing a DIMM from a Cisco ASR 1002-HX Router
Procedure
Step 1
With an ESD wrist strap on, remove the power supplies from the chassis.
Note
For instructions about how to remove the AC and DC power supplies, see:
• Removing AC Power Supplies
• Removing DC Input Power Supplies
Step 2
After the power supplies are removed, remove the chassis top cover by performing the following steps:
a) Remove the seven top surface screws on the chassis cover.
b) Remove the three screws from the rear of the chassis cover.
c) Remove one screw from the left side of the chassis and one screw from the right side of the chassis.
Figure 12: Cisco ASR 1002-HX Router Top Cover Screw Locations
d) Using both hands, gently slide the cover slightly backward and lift it off of the chassis.
Step 3
Position the chassis so that you have the most comfortable access to the chassis to remove the DIMM.
Step 4 Locate the DIMMs on the router.
The following figure shows the location of the DIMM slots in the .
Removing and Replacing FRUs
14
The chassis cover cannot be removed until the power supplies are removed from the chassis.
Removing and Replacing FRUs