Table of Contents
Advertisement
11-1BC(E)_P086-89
11/15/01
7:29 PM
Detail number
Standard set-
ting (0)
Function number
Superimpose
On
when focused
Rewind auto return
Auto return on
Leave film tip
Film tip not left
when rewinding
Selection of aper-
Aperture
ture stop-down
stopped down
button operation
while pressed
Focus button
SAF
function in "MF"
mode
Red-eye reduc-
Off
tion with internal
flash
Exposure com-
pensation setting
F dial
(with Av, P)
Exposure value
Align aperture
display when zoom
ring
lens is fitted (*)
Until power
Continued exposure
supply OFF
compensation
Exposure com-
F dial
pensation setting
CLE: Resetting cus-
The custom functions ( ~ ) are always set to the standard settings.
tom functions
• Note that if the exposure mode selector lever is set to any posi-
tion other than "CF" at this time, all the custom functions are
reset to the standard settings (i.e. to "0").
* When using lenses for which the open aperture value (brightness) with zooming varies
(eg. Vario Sonnar 28-80mm F3.5-5.6), the actual aperture is controlled by the camera so
that it assumes the value set with the aperture ring, rather than being controlled by zoom-
ing. Set Custom Function
to (1) to vary the aperture with zooming.
88
Page 88
Changed set-
Changed set-
Changed set-
ting (1)
ting (2)
ting (3)
Off
Auto return off
Film tip left
Aperture switches
between stopped
down and open
each time button
is pressed
CAF
On
F dial and
R dial
Link to zooming
Until setting
cancelled
Set with F dial
while pressing
LIGHT button
2. Setting custom functions
Display panel
Detail
The display panel is as shown at left
(custom function setting mode).
Function num-
Detail number
ber
Custom function setting mode
Function number
The custom function is set.
Return the dial to "
(green) and take the photograph.
The display panel returns to the normal
display.
• To initialize all set functions, display
Detail number
"CLE" as previously described in 2,
and set to a position other than "CF".
Set the position dial to "CF".
Turn the R dial to select
"Function number".
Turn the F dial to select "Detail
number".
Set the position dial to a position
other than "CF".
" (white) or "
"
89
Advertisement
Table of Contents
