Contax NX Instruction Manual page 11

04-1BC(E)_P013-024 11/15/01
3. Inserting the batteries and checking the battery
power
<Inserting the batteries>
Turn the main switch off before inserting the batteries.
Battery compart-
ment cover
Battery (CR2)
Display panel
16
7:27 PM Page 16
Open the battery compartment
cover.
Use a coin to turn the battery cover in
the direction of the arrow.
Insert two 3V lithium batteries
(CR2) into the battery compart-
ment. Ensure that the battery con-
tacts and those in the battery com-
partment match.
• The camera will not operate, and may mal-
function, if the batteries are inserted in the
wrong direction.
Close the battery compartment
cover.
The mark appears in the display
" "
panel.
• Even when using new batteries, during con-
tinuous shooting or at low temperatures, the
voltage may decrease momentarily and the
" " mark may light. If this happens, set
the main switch to OFF then back ON two
or three times. If the " " mark lights there
is enough battery power.
<Checking the battery power>
The meaning of the battery marks are as follows:
Check the battery power with the main switch turned ON.
Display when main
switch is on
There is sufficient battery power.
Battery power is low and will need replacement soon.
Replace with a new battery.
(flashing)
Camera will not operate.
(flashing)
Meaning
17