Dry Vacuum Mode - Bissell SPINWAVE 2931F Manual

Mop Mode
(continued)
Maintaining the Mop Pads and Debris Trap
While in Mop Mode, your robot can sweep up a limited amount of dry debris, so be sure to empty the
trap after each clean.
W ate r
1.
Turn the Power Switch OFF.
Press the button on top of the
Mop Tank and pull to remove.
Place tank upside down on a
soft surface.
4.
To reattach, use the middle
hole on the pads to align with
the driver.

Dry Vacuum Mode

For more help, visit support.BISSELL.com.
Manual Cleaning
In Dry Vacuum Mode, your robot will clean using a combination of dual Edge-Cleaning Brushes, a
rotating brush roll and powerful suction to clean multiple floor types in your home.
1.
Turn the robot ON. Press
the Start/Pause Button to start
cleaning.
8 BISSELL.com
2.
Firmly pull up on the Mop
Pads to remove from mop pad
drivers. Replace Mop Pads if
damaged.
5.
The debris trap is located
on the back of the tank. Pull
down the door and tip tank to
empty debris.
2.
When finished, press the
Start/Pause Button again to
stop the robot.
3.
Machine wash separately
in warm water. Use only liquid
detergents. Do not use bleach
or fabric softener. Tumble dry
on low. Do not iron or dry clean.
x2
3.
Return the robot to the dock.
Press the Start/Pause Button
twice. The light ring will flash
white as it finds its way back.