Internal Memory/Inserting The Memory Card - Concord Camera Eye-Q 3341z Quick Start Manual

Setting the Time
ADJUST TIME
0 1 : 0 1 A M
RETURN SET
OK
The time is displayed in hour, minute format.
1. Press to change the selection in the blinking position until you reach the desired setting.
2. Press to highlight the hour (HH), minutes (MM) or AM/PM.
• The selection will blink when it is highlighted.
3. Repeat steps 1 and 2 until the time is set.
4. Press to set the time.
Note:
The time can be displayed in a 12-hour or 24-hour format. Please go to page 31 in the Use's Guide to
change this setting. If the battery is removed or dead for more than 4 minutes, the time will return to its
default setting.

INTERNAL MEMORY/INSERTING THE MEMORY CARD

Internal Memory
The camera is equipped with 16MB of internal memory, which can be used right away.
Inserting the Memory Card
In addition to having a 16MB internal memory, the camera can use Secure Digital (SD) memory cards to store
images and video clips.
fig.1.1
1. Open the Battery/Memory Card door.
• Slide the door in the direction of the arrow marked on it, and lift it open. (fig.1.1)
2. Insert the memory card as indicated by the diagram. (fig.1.2)
• Please insert the card in straight, not on an angle.
3. Shut the Battery/Memory Card door by sliding it in the opposite direction of the arrow marked on it, and
close it securely. (fig.1.3)
Ejecting the Memory Card
1. To eject the card, push the card in and release, then pull the card out.
ADJUST TIME
0 1 : 0 1 A M
RETURN SET
OK
fig.1.2
4
GETTING STARTED
ADJUST TIME
0 1 : 0 2 AM
RETURN SET
OK
fig.1.3