Westfalia 20 58 23 Instruction Manual page 12

Ultrasonic Marten Repeller
acoustic noise can constantly spread and is not absorbed
by insulating mats.
ATTENTION: Assembling should be carried out by
authorised specialised staff!
Electrical Connection
The device is directly connected to the car battery and
binder 15. The red cable is connected to the positive pole,
the black cable is connected to binder 15, which you find
at the plug for the car radio which is marked according to
the Euro Norm. Having established this type of connec-
tion, the device works only when the ignition is turned off.
The electric power consumption is lower than the one of a
car quartz watch.
After having connected the operating voltage of 12 V
direct current, the LED indicator (1), which is installed in
the device, will slowly flash. In case this control lamp does
not flash, there is either no electric connection or the
polarity of the electric connection is wrong (positive and
negative polarity is swapped).
General notes
When your car already has been visited by martens, most
likely the animals have left their marks for the identification
of their area. These odours must unconditionally be
removed before installing the Ultrasonic Marten Repeller.
Or other martens could even enter a bite protected engine
compartment. To prevent this, washing the motor thor-
oughly is suggested. Furthermore, the animals leave their
7