General; Introduction; Scope Of Delivery; Intended Use - Ten-Haaft Oyster Operating Instructions Manual

1. GENERAL

1.1 Introduction

These instructions describe the function and the operation of the Oyster® Smart TV.

1.2 Scope of delivery

Oyster® Smart TV with remote control and on-board voltage connection cable.

1.3 Intended use

The intended use of this product is the use as TV or monitor in motorhomes or caravans. Please observe the specifica-
tions of the respective vehicle manufacturer for wall installation. Use only mounting elements that comply with the
VESA standard.
The voltage supply must be provided by a standard vehicle electric system with a rated voltage of 12V / 24V DC.
No switching regulator may be used for the power supply when the product is installed in caravans.
Any use other than specified is not permitted.

1.4 Safety Instructions

To prevent deep discharge of the battery systems, the TV has a mechanical circuit breaker (mains switch) for
complete disconnection from the mains. If this switch is not used, suitable measures must be taken on- board to
prevent deep discharge of the battery systems.
The manufacturer accepts no liability whatsoever for direct or indirect damage or consequential damage to the
equipment itself, battery systems, motor vehicles or other goods resulting from the connection of unsuitable
battery systems or from installation errors or wiring faults.
4

2. CONTROL ELEMENTS

2.1 Remote control

But-
ton
APPS
0 - 9
EPG
EXIT
START
COUNTRY
PARK
STOP
FAV
AQT
TIME
SHIFT
SWAP
OK
SETUP
SOURCE
Function
Power ON/OFF
Direct call of the app selection
Direct input of the programme number, for example
Electronic TV guide
Quit menu/OSD
(Re-)extend antenna*
Selection of the current location*
Retract antenna*
Stop antenna*
Call up list of favourite programmes
Without function
Starts channel search (only DVB-T mode)
Without function
Skip back to previous programme
Confirm selection
Call up main menu
Select source (DVB-S/DVB-T/HDMI, etc.)
5