Channel Settings And Search Run (Dvb-T2); Picture - Ten-Haaft Oyster Operating Instructions Manual

3. OPERATION OF THE OYSTER® SMART TV
Signal information
Shows strength and quality of reception.
Software update (USB): Allows you to update the software via USB. Only use software that originates directly
from ten Haaft.

Channel settings and search run (DVB-T2)

(First, the TV must be set to DVB-T by means of
Press to navigate to the main menu, then select channel.
SETUP
Note: Satellite has the same frequency all over Europe; the frequencies for DVB-T differ depending on region.
28
)
SOURCE
3. OPERATION OF THE OYSTER® SMART TV
Automatic search: Press to execute a new terrestrial channel scan. All services found during the scan are
OK
shown in the list.
Manual DVB-T search: Allows you to carry out a manual search. You can search an individual frequency for a
channel in a targeted manner.
5V Antenna supply: Switch the 5V power supply on and off.
Editing the DVB-T programme: Enables you to delete, skip and add channels to the list of channels. The button
deletes the selected channel, skips the selected channel. Press the button
RED BLUE
favourites. For more detailed information see page 27, under "Satellite".
Signal information: Indicates the strength and quality of the channel signal.
Software update (USB): Allows you to update the software via USB. Only use software that originates directly
from ten Haaft.

PICTURE

In this menu you can change different settings for the picture of the Oyster® Smart TV. Here you can make the
following settings:
to compile a list of
FAV
29