Camera Installation - NewLine FLEX Quick Manual

・ Unpacking your Newline Flex
1. Lay the carton on a flat
surface and open the box.
・ Newline Flex can be tilted up to 45 degrees
45°
・ Camera Installation
2. Remove the packing
materials.
Camera Front Facing Installation:
With the camera facing forward,
align the USB Type-C Connector and
gently push down until fully seated.
Use the two thumb screws to secure
the modular camera to the Flex.
3. Lift the Flex out of the box
and set on a flat sturdy surface.
45°
4. Remove remaining packaging
materials and setup up in
designated area.
Camera Rear Facing Installation:
With the camera facing to the rear,
align the USB Type-C Connector and
gently push down until fully seated.
Use the two thumb screws to secure
the modular camera to the Flex.
F L E X Q u i c k G u i d e