Troubleshooting - Bennett Read MULTI-FORCE User Manual

TROUBLESHOOTING

PROBLEM
Vacuum cleaner
1. Power cord not firmly plugged in
won't run
2. Power button not pressed down
Vacuum cleaner
1. Tools, hose or extension wands
doesn't vacuum
effectively
2. Filters are dirty
3. Dirt container is full
4. Hose connector not securely
5. Crack or hole in hose
6. Air-flow regulator is set to open
7. Blocked dirt container
Dust blows out
1. Dirt container is full
of the air vents
2. Filters missing or installed
3. Filters are dirty
4. Hose connector is blocked
5. Hose connector is not securely
6. Crack or hole in hose
WARNING:
!
To reduce the risk of electric shock, turn the
Power Switch OFF and disconnect the plug
from the electrical outlet before performing
troubleshooting checks.
POSSIBLE CAUSES
are blocked
attached to suction inlet
incorrectly
attached to the suction inlet
Other maintenance or service not included
in the manual must be performed by an
authorized Tevo service representative. For
any questions or concerns, contact customer
care on 0861 77 88 88.
10
REMEDIES
1. Check electrical plug
2. Press power button
1. Remove each part
and check for
blockages
2. Follow instructions
for cleaning filters
on pages 7 - 9
3. Follow instructions
for emptying the dirt
container on page 6
4. Check that hose
connector is locked
into suction inlet
5. Check hose and
replace if necessary
6. Change to closed
7. Clear blockage from
the dirt container
following steps 1 to
7 at the top of this
page.
1. Empty the dirt
container
2. Check all filters for
correct installation
3. Check and clean or
replace all filters
4. Remove hose and
check for blockages
5. Make sure the hose
connector is locked
into the suction inlet
6. Check hose and
replace if necessary