Troubleshooting; Technical Specifications - Bennett Read TOUGH 12 User Manual

TROUBLESHOOTING

PROBLEM
Machine not
switching on
Weak suction
power
Visible dust
escaping from
the machine
while vacuuming
Machine switches
off during
operation
(Thermal Cut-off
Switch)
Other maintenance or service not included in the manual should be performed by
an authorized Tevo service representative.
For any questions or concerns, please contact customer care listed on page 10.

TECHNICAL SPECIFICATIONS:

Nominal voltage: 220-240 V AC
Nominal frequency: 50/60 Hz
Power output : 800 - 1000W
Dirt Tank capacity : 12 Litres
POSSIBLE CAUSES
1. Power cord not rmly plugged in
or not switched on at wall socket
1. Filter Bag dirty or clogged
2. Obstruction in Flexi-Hose,
vacuum nozzle or extension
pipes
1. Filter Bag not installed
2. Filter Bag dirty
1. Filters dirty or clogged, or the
Filter Bag is full
2. Obstruction in the Flexi-Hose or in
the extension tube
The machine will only switch on after it has cooled down
suf ciently. Permanent damage will be caused to your machine
if you continue to use it without addressing the root cause of the
overheating as explained above
1. Check electrical plug
1. Remove and clean
Filter Bag as explained
on page 8. It is
important to check and
clean the bag regularly
2. Remove Flexi-Hose,
nozzle and extension
pipes.
Clean and check for
any obstructions
1. Check Filter Bag,
situated inside the
Dirt/Water Tank
2. Clean Filter Bag as
explained on page 8
1. Clean or replace Filter
Bag as explained on
page 8
2. Check and clean the
Flexi-Hose and the
Extension Wand
9
REMEDIES