Honda DREAM125 2018 Owner's Manual page 88

#
Rear Wheel
Removal
1. Support your motorcycle securely and raise
the rear wheel off the ground using the
centre stand or a hoist.
2. Remove the drive chain cases.
3. Remove the rear brake adjusting nut.
4. Disconnect the brake rod from the brake
arm.
5. Disconnect the brake stopper arm from the
brake panel by removing the cotter pin,
brake stopper arm nut, washer and rubber
grommet.
Drive chain
lock nut
P. 69
2
Rear brake
adjusting nut
6. Loosen the drive chain lock nuts and drive
chain adjusting nuts on both sides of the
drive chain adjuster.
7. Remove the rear axle nut while holding the
rear axle shaft at the other end with a
wrench.
Tyre Puncture Removing Wheels
u
Drive chain
adjusting nut
Brake arm
Rear axle nut
Drive chain
adjuster
Brake stopper
arm nut
Brake rod
Cotter pin
Brake stopper arm
continued
83