Software Installation; Preparation Of Device; Print - FLASHFORGE 3D PRINTER Adventurer 4 Quick Start Manual

Find the FlashPrint installation package in the USB disk and select the version
corresponding to your system to install.
Or you can download it from https://www.flashforge.com/download-center.
1.Connect to power.

Software Installation

Preparation of Device

The equipment has been leveled and calibrated before
delivery, but due to transportation or other influences,
the distance between nozzle and platform may change.
It is recommended to conduct [Calibration] after
unpacking.
This step is optional, please refer to the interface
function introduction before operation.
Power Switch

Print

Connect cable to printer;
turn on the switch, the
screen lights up.
03