Table of Contents
Advertisement
Hearing Assist System Operation
Basic instructions are described below and shown in Figure 27. For more information, refer
to the Listen LT-800 Stationary Transmitter, Listen LR-4200 iDSP Receiver, and Listen LA-122
Universal Antenna Kit Users Manuals.
1� Press POWER to turn on the transmitter if it is not already on.
2� Use the CHANNEL SELECT buttons to select a channel.
3� Plug the Ear Phone/Neck Loop lanyard into the 2 jacks on top of the receiver, and
then connect the Ear Speaker into the jack on the lanyard.
4� Press and hold the power button for 1 second to turn on the receiver. (To turn off the
receiver, press and hold the power button for 3 seconds.)
5� Verify the channel number matches on both the receiver and the transmitter. To
change the channel, press and hold the up and down buttons at the same time for
5 seconds, and then use the up and down buttons to select the channel. Press the
power button to save.
Note: Receivers use rechargeable Lithium-ion batteries. Always charge receivers at
least 2.5 hours before the event.
6� Repeat steps 3–5 for any additional receivers.
1
Figure 27: Optional Hearing Assist System
2
4
3
Setup & Operation
17
5
Advertisement
Table of Contents
