Wireless Mic System Operation; Wireless Receiver; Single Receiver; Network Receivers - Daktronics SPORTSOUND SSR-300 GEN II Operation Manual

Wireless Mic System Operation

Basic instructions are described below. For more information about wireless mic system
operation, refer to the Shure QLX-D Wireless System User Guide.

Wireless Receiver

b
a
d
Figure 23: Wireless Receiver LCD & Controls
The unit displays the following information (Figure 23):
a� Transmitter Battery Life
b� TV Channel
c� Frequency
IR Window
d� Group Number
e� Channel Number
f�
RF Signal Strength
g� Transmitted Audio Level
h� Gain Level

Single Receiver

1� Ensure all transmitters are powered off� Press the power button to turn on the receiver
if it is not already on.
2� Press menu until "scan" displays on the LCD.
3� Press enter to start frequency scan. When scan is complete, Group and Channel will
display on the LCD.

Network Receivers

1� Ensure all transmitters are powered off� Turn on all receivers and wait one minute to
allow time to connect to the network.
2� Press menu on one receiver until group number flashes.
3� Use the arrow buttons to select a group to scan.
4� Press enter, wait for channel, and then press enter again
5� Press menu until "network scan" displays on the LCD.
6� Press enter twice to deploy channels to other receivers.
Note: Perform a scan on all of the wireless units just minutes before the game! If a scan
is performed too far ahead of time, frequencies set up by the media later on may
interfere with previously configured wireless microphone settings.
c
h
e g
f
IR Window
Power
ON/OFF
Setup & Operation
12
Power
Power
ON/OFF