Table of Contents
Advertisement
Powering On
Open the rear rack door to find the power cord in the lower-left corner (Figure 17). Route
the plug down through the hole in the bottom of the rack and out of the knockout/strain
relief. Connect the power cord into a standard 120V grounded outlet.
Figure 17: Power Cord & Strain Relief
Turn the SOUND SYSTEM key switch (Figure 18) to the ON (vertical) position.
Note: Keep keys in a safe location to prevent theft/tampering of rack equipment!
Figure 18: Power Key Switch
Before continuing, be sure to also power on the speaker cabinet(s)�
Mixer Operation
Basic startup instructions are described below. For more
information about audio mixer operation, refer to the
Yamaha Digital Mixing Console TF Series Reference
Manual.
1� Under USER DEFINED KEYS, press the button labeled
"B" (Figure 19).
Note: Custom keys (presets) may have been set up during training. Press the desired
key as needed for a specific application. The creation of additional presets is
recommended for advanced users only.
2� Ensure all source equipment is turned on and operational (refer to the appropriate
sections of this manual and/or manufacturers' manuals).
Setup & Operation
10
Figure 19: User Defined Keys
Advertisement
Table of Contents
