Residual Risks; Safety Warnings And Instructions - Black+Decker LD12 Manual

f Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body leaves
it unstable and may lead to loss of control.
f Before drilling into walls, floors or ceilings check for
the location of wiring and pipes.
f Avoid touching the tip of a drill bit just after drilling, as
it may be hot.
f This tool is not intended for use by persons(including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety. Children should be supervised to
ensure that they do not play with the appliance.
f The intended use is described in this instruction
manual. The use of any accessory or attachment or
performance of any operation with this tool other than
those recommended in this instruction manual may
present a risk of personal injury and/or damage to property.

RESIDUAL RISKS

Additional residual risks may arise when using the tool
which may not be included in the enclosed safety warnings.
These risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
f Injuries caused by touching any rotating/moving parts.
f Injuries caused when changing any parts, blades or
accessories.
f Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you take
regular breaks.
f Impairment of hearing.
f Health hazards caused by breathing dust developed
when using your tool (example: working with wood,
especially oak, beech and MDF).

SAFETY WARNINGS AND INSTRUCTIONS

BATTERIES
f Do not disassemble or open, drop (mechanical
abuse), crush, bend or deform, puncture, or shred.
f Do not modify or remanufacture, attempt to insert
foreign objects into the battery, immerse or expose
to water or other liquids, or expose to fire, excessive
heat including soldering irons, or put in microwave oven.
f Only use the battery with a charging system specified
by the manufacturer/supplier.
f Do not short-circuit a battery or allow metallic or
conductive objects to contact both battery terminals
simultaneously.
f Dispose of used batteries promptly according to t.0he
manufacturer/supplier's instructions.
f Improper battery use may result in a fire, explosion,
or other hazard.
f Battery usage by children should be supervised.
Warning! Never attempt to open the battery for any
reason. If battery case is cracked or damaged, do not
insert into charger. Do not crush, drop or damage battery.
Do not use a battery or charger that has received a sharp
blow, been dropped, run over or damaged in any way
(i.e., pierced with a nail, hit with a hammer, stepped on).
Damaged batteries should be returned to service center
for recycling.
CHARGER
1. This manual contains important safety and operating
instructions.
2. Before using battery charger, read all instructions and
cautionary warnings on battery charger and product
using battery.
Caution! To reduce the risk of injury, use charger only
with this product. Batteries in other products may burst
causing personal injury or damage.
3. Do not expose charger to rain or snow.
4. Use of an attachment not recommended or sold by
BLACK+DECKER may result in a risk of fire, electric
shock, or injury to persons.
5. To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting charger.
6. Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage
or stress.
7. An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire, electric shock or electrocution.
a. Two-wire cords can be used with 2-wire or 3-wire
extension cords. Only round jacketed extension
cords should be used, and we recommend that
they be listed by Underwriters Laboratories (U.L.).
If the extension is to be used outside, the cord
must be suitable for outdoor use. Any cord marked
for outdoor use can also be used for indoor work.
The letters "W" or "WA" on the cord jacket indicate
that the cord is suitable for outdoor use.
b. An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety, and
to prevent loss of power and overheating. The
smaller the gauge number of the wire, the greater
the capacity of the cable; that is, 16 gauge has
more capacity than 18 gauge. When using more
than one extension to make up the total length,
be sure each extension contains at least
the minimum wire size.
ENGLISH • 5