Interfacing To The Rtt Through The Enervista 750/760 Setup Program - GE RTT Instruction Manual

THE SR750/760 FEEDER MANAGEMENT RELAY
2.2.5

Interfacing to the RTT through the EnerVista 750/760 Setup Program

2.2.5.1 Current
2.2.5.2 Voltage
24
The following information describes how to configure the SR750/760 relays and how to
monitor voltage and current inputs using the 750_760 Setup Software and the RTT.
Setup: Enter the Phase CT Primary then Save
Metering: View the current values measured by the relay, in real-
time.
Setup: Configure the Bus VT Connection Type, enter the the Bus VT
Ratio, then Save.
CHAPTER 2: USING THE RTT ON SR SERIES RELAYS
FIGURE 2–13: Current Setup
FIGURE 2–14: Current Metering
FIGURE 2–15: Voltage Setup
RTT DESKTOP TEST SET– INSTRUCTION MANUAL