Troubleshooting - Electrolux Refine 700 Instruction Book

EN
FABRIC
CNS
Denim
CNT
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the
recommendations in the table!
KR

TROUBLESHOOTING

ID
PROBLEM
TH
Soleplate is not heating
even though iron is turned
VN
on.
Iron does not produce
steam.
Steam jet and vertical
steam jet function does not
work.
Water leaks from the
soleplate during ironing.
Flakes and impurities come
out of the soleplate during
ironing.
Water leaks from the
soleplate while the iron is
cooling down or after it has
been stored.
Brown streaks come out of
the soleplate while ironing
and stain the linen.
8
TEMPERATURE SET-
TING
Cotton or Linen
POSSIBLE CAUSE
Connection problem
Temperature control is in
"Outdoor" position.
Not enough water in tank.
Selected temperature is lower
than that specified to use with
steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water,
which has caused scale flakes to
develop in the water tank. Clean
the iron according to Cleaning
section.
The iron has been put in
horizontal position while there is
still water in the water tank.
You may have used chemical
descaling agents different from
the recommendation.
Fabric fibers have accumulated
in the holes of the soleplate and
are burning.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed
before ironing.
IRONING RECOMMENDATION
Use maximum steam. Apply maximum steam by
pressing and holding the steam on/off button.
SOLUTION
Check main power supply cable, plug
and outlet.
Select higher programme like "
Cotton".
Fill water tank (see "Getting started",
no 2).
Increase temperature to at least "
Cotton".
Put iron on horizontal position and
wait before using steam jet function.
Adjust the proper temperature to
steam ironing (up to "
iron in vertical position and wait until
temperature indicator light turns off.
Select the Cotton setting ("
to maximum) suitable for steam
ironing. Put the iron on its heel and
wait until the headlight is on before
you start ironing.
Press and hold the steam button for
about one minute to get steam. Then
hold one more minute in order to clean
the steam generating system. Before
starting ironing, please test your iron
on an old towel to ensure that no
residues inside the iron are transferred
to your garments.
Empty the water tank.
To prevent this from happening, it is
recommended to exchange the Soft
Water Activator according to the
indications.
Clean the soleplate with a damp soft
cloth.
Please rinse the fabrics properly
before ironing.
Cotton"). Put
Cotton"
www.electrolux.com