M-system R10-BS1 Instruction Manual

INSTRUCTION MANUAL
INSTALLATION BASE
BEFORE USE ....
Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System's Sales Office or representatives.
■ PACKAGE INCLUDES:
Installation base ..................................................................(1)
■ MODEL NO.
Confirm Model No. marking on the product to be exactly
what you ordered.
■ INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.
POINTS OF CAUTION
■ CONFORMITY WITH EU DIRECTIVES
• The equipment must be mounted inside the instrument
panel of a metal enclosure.
• The actual installation environments such as panel con-
figurations, connected devices, connected wires, may af-
fect the protection level of this unit when it is integrated
in a panel system. The user may have to review the CE
requirements in regard to the whole system and employ
additional protective measures to ensure the CE conform-
ity.
■ GENERAL PRECAUTIONS
• Before you remove the unit or mount it, turn off the power
supply, input and output signals for safety.
■ ENVIRONMENT
• Indoor use.
• When heavy dust or metal particles are present in the
air, install the unit inside proper housing with sufficient
ventilation.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -10 to +55°C
(14 to 131°F) with relative humidity within 10 to 90% RH
in order to ensure adequate life span and operation.
■ WIRING
• Do not install cables close to noise sources (relay drive
cable, high frequency line, etc.).
• Do not bind these cables together with those in which
noises are present. Do not install them in the same duct.
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
MODEL
INSTALLATION
Mounting Unit Lock Slot
Mounting Unit Cursor Key
Note: The side of mounting unit lock slot have No. 1 – 10
terminal connections.
■ TERMINAL ASSIGNMENT
1 2
IO1 IO2
6 7
IO6 IO7
11 12
FE DB
16 17
SLD DG
PIN
ID FUNCTION
NO.
1 IO1 I/O Terminal 1
2 IO2 I/O Terminal 2
3 IO3 I/O Terminal 3
4 IO4 I/O Terminal 4
5 IO5 I/O Terminal 5
6 IO6 I/O Terminal 6
7 IO7 I/O Terminal 7
8 IO8 I/O Terminal 8
9 IO9 I/O Terminal 9
10 IO10 I/O Terminal 10
R10-BS1
Slider
1 2 3 4 5
6 7 8 9 10
Specification
(side)
11 12 13 14 15
16 17 18 19 20
Slider
3 4 5
IO3 IO4 IO5
8 9 10
IO8 IO9 IO10
13 14 15
DA NC FE1
18 19 20
NC 24V 0V
PIN
ID FUNCTION
NO.
11 FE Modbus ground
12 DB DB
13 DA DA
14 NC Unused
15 FE1 Power ground
16 SLD Shield
17 DG DG
18 NC Unused
19 24V Power supply 24V DC
20 0V Power supply 0V DC
EM-6248 P. 1 / 4