Steering Friction Adjusting Screw; Trim Tab - Yamaha F20A Owner's Manual

408031
q
A
w
B
603013
2-10
EMU00108
STEERING FRICTION ADJUSTING
SCREW(for Tiller control model)
A friction device provides resistance to
steering movement. This is adjustable for
operator preference.
screw/bolt is located on the swivel brack-
et.
EMU00111*
Adjustment
Resistance Screw/Bolt
Increased Turn clockwise
Decreased Turn counterclockwise
w
Do not over
screw/bolt. If there is too much resis-
tance, it may be difficult to steer, which
could result in an accident.
EMU00114

TRIM TAB

The trim tab should be adjusted so that
the steering control can be turned to
either the right or left by applying the
same amount of force.
w
An improperly adjusted trim tab may
cause difficult steering. Always test run
after the trim tab has been installed or
replaced to be sure steering is correct. Be
sure you have tightened the bolt after
adjusting the trim tab.
1 Trim tab
2 Bolt
Boat tends to veer
To the left
(port side)
To the right
(starboard side)
GB
An adjusting
tighten the friction
The fin of trim tab
Turn to the left(port side),
"A" in the figure
"Turn to the right
(starboard side),
"B" in the figure